Right click over image and SAVE TARGET AS -
for low compression/hi-res 300dpi picture - 0.9MB

DEBURRING & POLISHING IN LESS TIME SAVES DOLLARS

Perfect for a small job shop, cell production within larger manufacturers and just-in-time processes, the ECO is sure to increase productivity and profitability. A compact footprint and the need for only a 115 volt 60Hz single phase power input means the device is truly plug and play and can be located near to CNC machines in the cell.

Vice president, Jonathan Dean, explains, "The ECO is so easy to use. It achieves fantastic and repeatable results without supervision, freeing time to work on more productive tasks. Processing is fast - sometimes as little as one minute is all that is required. Being up to 10 times faster than vibro machines and 20 times faster than conventional barrel finishing, means the ECO keeps pace with CNC production and can reduce need for batching. Being small and quite too, means the ECO addresses the space, and health and safety concerns associated with traditional deburring."

ECO is available with five liter and nine liter processing barrels in single or twin configurations. The system can be used for dry or wet processing and has an optional dosing pump. There is even an ECOmini, wet or dry, for truly small scale use.

For the more demanding industrial users who need higher throughput while maintaining exacting standards of finish, Otec recommends the CF range of machines. See the new ECO and CF on the Otec Precision Finish Inc booth B-7231 at IMTS 2002.

A free consultancy and test processing service for new users is provided by Otec Precision Finish Inc.

Uploaded: May 30, 2002

More information: Ed Pastore, Vice President, OTEC Precision Finish Inc.
Toll Free: 1-888 511 6832, Tel. 978 635 1964 Fax: 978 635 1478
Email: sales@otecusa.com Web: www.otecusa.com